adhesive friction
英
美
[网络] 黏著摩擦
双语例句
- Using friction coefficient tester, we have investigated the humility and UV-light dependence of the adhesive force and friction coefficient on glass surface and nano-TiO 2 film coated glass surfaces in the relative humidity of 30%~ 70%.
在30%～70%的相对湿度范围，使用摩擦系数测定仪，研究了玻璃表面和玻璃基体上纳米二氧化钛光致双亲性膜的摩擦系数与紫外光和环境湿度的变化规律。 - With the increase of the concentrations of peroxide solutions, the degree of adhesive wear weakened and the friction coefficient decreased. In high concentration of peroxide solutions, the main wear mechanism of ceramic materials was corrosive wear, abrasive wear and the friction coefficient increased.
随着H202介质溶液浓度的增大，粘着作用减弱，摩擦系数减小，高浓度H202介质溶液中，Si3N4陶瓷材料的磨损以腐蚀磨损和磨粒磨损为主，摩擦系数增大。 - Results show that for certain fractal dimension, the total adhesive friction coefficient reduces sharply as the normalized contact area increases.
结果表明，对于一定的分形维数，总的粘着摩擦系数随归一接触面积的增大而急剧减小。 - The main contents are as following: ( 1) Discusses the adsorption force consists of adhesive force, negative pore water pressure and side friction.
本文的主要内容：（1）论述了吸附力由粘着力、负孔隙水压力、侧摩阻力组成。 - As adhesive, matrix resin accounted for a larger proportion in non-metallic and semi-metallic friction material. Its performance direct impacts on the using performance of friction material.
基体树脂作为粘接剂，在非金属、半金属摩擦材料中所占的比例较大，其性能的好坏直接影响摩擦材料的使用性能。 - Adhesive friction and Transporting Safety
附着摩擦与运输安全性 - Assuming that the yield pressure and the local adhesive friction coefficient are independent on the contact spot and equal to the average values in the plastic contact regimes, the total adhesive friction coefficient is given by simple formulae.
假设屈服压力及局部粘着摩擦系数不依赖于接触斑点且等于塑性接触区中的平均值，则总的粘着摩擦系数可用简单的表达式描述。 - It provides theoretical foundation for determining the size of pressing load. Finally, a fractal model of adhesive friction coefficient is proposed by comparing the normal elastic load with the normal plastic load acting on particle contact points.
最后，通过比较作用于颗粒接触点的法向弹塑性载荷，提出了粘着摩擦系数的分形模型。 - The adhesive wear and abrasive wear were both existed in the wear mechanism of the composite material, the friction coefficient fluctuated with time changed.
复合材料的磨损机制是黏着磨损和磨料磨损交替进行，摩擦系数随时间的变化上下波动。 - Thermal shock cracking in friction surface, over heated and over burned microstructure in sub surface, adhesive element diffusion from surface to center occur due to friction heat. Layer delamination occurs also on the worn surface of the steel.
因摩擦热的影响，制动后钢的摩擦表面出现热震开裂，表层组织过热甚至过烧，表面的粘着物由表向里扩散；